A few short steps to constructing an electrode
The electrode module largely automates the construction process in hyperCAD®-S. Seamless technology and component data transfers in hyperMILL® also ensure fast, reliable programming. The entire process is so highly supported that programmers can carry it out with just a few clicks, without requiring any construction knowledge.
Highlights in creating electrodes
The programmer selects the faces to be eroded on the component geometry. The module creates corresponding collision-free electrodes. This means that it can automatically ensure the extension of the electrode faces and the derivation of raw material and holders.
Seamless transfer into the hyperMILL® CAM system is based on the geometry as well as the technological information. The programmer selects the electrodes to be programmed at this point and starts programming using further technology definitions. If there are machining macros in place, the programming is conducted automatically.