The Multiblade package

5-axis CAM software – the Multiblade package from OPEN MIND: As simple as a standard application.

Impellers and blisks can be programmed without special knowledge using this application. Integrated automated functions in the Multiblade package reduce the number of parameters that need to be entered to a minimum. Proven collision checking guarantees a very high level of process reliability. The use of robust tools allows machining with high infeed parameters and feed rates.

5-axis Machining: Impeller milling

Faster machining with FANUC and hyperMILL® CAM software to meet the manufacturing challenges of engine components.

Want to watch our videos?

Then please enable cookies to view this content.

Enable cookies

 

Would you like to learn more about the Multiblade package of our complete CAM solution?

For contact:
OPEN MIND Technologies USA, Inc.
1492 Highland Avenue, Unit 3, Needham MA 02492

Multiblade roughing

In the roughing cycle, the blades are machined in a continual process starting from pre-turned stock or a semi-finished workpiece. No time-consuming simulation of the removal of material is required.

Multiblade plunge roughing

Plunge roughing is an alternative if a horizontal feed rates cannot be effectively achieved with long, slim tools. This process allows the most rigid tool to be employed to rough a pocket between blades. This is provided as an optional module.

Multiblade hub finishing

The toolpath profile can adjust the hub’s aerodynamic behavior and appearance to suit individual customer requirements. This machining strategy can also be applied as rest machining near blades.

Multiblade point milling

This HSC strategy is characterized by continuous, spiral machining movements with tool point contact. This allows superb milling of even highly curved blades.

Multiblade flank milling

If the blade surfaces allow for sufficiently precise swarf cutting, the Flank Milling cycle can be used. This reduces machining time. hyperMILL® 5AXIS automatically calculates the optimal tool nestling.

Multiblade edge milling

This machining strategy is used whenever leading and trailing edges cannot be generated together with the flow areas in a single operation.

Multiblade fillet milling

This is the ideal strategy when the radii between the hub and the blade surfaces vary. This strategy also facilitates rest material machining – the basic requirement for choosing an optimal tool for blade and hub machining.

Free OPEN MIND WEBINAR!

hyperMILL® webinar in collaboration with EMUGE-FRANKEN

mobile-s mobile-m mobile-l tablet desktop-s desktop-m desktop-l desktop-xl